The gauge management software QMSOFT®

Modules

Inspection program QMSOFT® / QM-SPLINE

The inspection program QMSOFT®/QM-SPLINE is designed for the inspection of involute and straight sided spline gauges according to different national standards, respective according to customized factory standards.

At time the program is exclusively designed to measure and evaluate a "Two-point" measurement over or between pins for the different types of gages for external and internal splines to check the gauges actual "space width" or "tooth thickness". The measurement of "Form diameter", "Minor diameter" or other gauge parameters is not a part of this program! The program does calculate the nominal measures over or between two pins in dependence of the pin diameter selected and compares it with the actual measures. The following standards form the basis of the evaluation:

• Involute spline gauges acc. to DIN 5480, October 1991 and DIN 5480, March 2006
• Involute spline gauges acc. to DIN 5482; March 1973
• Straight sided spline gauges acc. to DIN 5481; January 1952
• Involute spline gauges acc. to ANSI B92.1-1996
• Involute spline gauges acc. to factory standards
  (entering tooth thickness or space width)

Results can be produced on the screen and/or the printer and/or in a file. The nominal values of the gauge will be processed in connection with the inspection conditions and the measurement results in the results record. Tolerance excesses are marked and identified. It is possible to customize calibration certificates using the so called "certificate layout files" (templates).

The program can be started up directly from the QMSOFT®/QM-MANAGE gauge data management system. In this case it will receive all necessary nominal data necessary directly from the data base. At the end of the inspection the results and the calibration certificate will automatically be transferred back to the data base program.

Top